OPERATING AND MAINTENANCE MANUAL
Chapter 7 - Electronic controller
iC 215 ÷ iC 780
45
The data in this manual are not binding and they can be modified by the manufacturer without notice.
Reproduction of this manual is strictly prohibited
EN
ENGLISH
The parameter families, identified by “Labels”, are divided as follows:
ATTENTION
Configuration parameters “CF” are editable only with the unit in Stand-by.
7 . 1 2 . 1
A c c e s s t o p a r a m e t e r s
To enter the parameters menu “
Pr1
” (user level):
1. Press
+
for 3 seconds. The upper display shows the label “
PASS
”, the lower display shows the label
“
Pr1
”.
2. Press
, the upper display shows flashing “0”.
3. To enter the password use
or
.
4. If the password entered is incorrect, you will be prompted to enter it again. If the password is correct press
to
display the parameters. The upper part of the display shows the first label “
ALL
”.
5. To select the labels press
or
and then press
. The lower display shows the label and the code of the
first parameter it contains; the upper display shows the associated value.
ATTENTION
Certain parameters may be read-only. If a parameter is read-only LEDs 1 and 2 will flash.
To exit programming mode and return to normal display mode press
+
simultaneously.
LABEL
ACTION
ALL
Displays all parameters
ST
Displays Thermoregulation parameters only
dP
Displays Display Presentation parameters only
CF
Displays Configuration parameters only
SD
Displays dynamic setpoint parameters only
ES
Displays energy saving and starting parameters only (FUNCTION NOT ACTIVE)
Displays second setpoint parameters only
CO
Displays Compressor parameters only
US
Displays auxiliary output parameters only
FA
Displays Fan parameters only
Ar
Displays anti-freeze heater parameters only
DF
Displays defrost parameters only
rC
Displays Recovery parameters only
AL
Displays Alarm parameters only
Pr
Password
LED 4
LED 1
LED 2
LED 3