![background image](http://html1.mh-extra.com/html/ics/695gc-f4/695gc-f4_service-manual_3553851041.webp)
©2012 ICS - Blount Inc, Specifications subject to change without notice. REV11272012 P/N 546529
41
695GC/F4 SERVICE MANUAL
13. IGNITION MODULE
13.1
• Remove starter cover.
• Remove starter cover shield.
• Disconnect the stop switch cable.
• Inspect and replace if damaged
(P/N 544032).
13. This section covers the removal, inspection and installation of the ignition module.
Removal of the starter is required. Refer to section 8 if necessary.
13.2
• Remove (2) ignition module screws
(P/N 544038).
• Remove ignition module (P/N 544036).
• Inspect and replace if damaged.
13.3
Reassemble in reverse order.
Place air gap gauge (.010 in/0.3 mm) on
the magnet side of the flywheel.
• Set ignition module in place.
• Install ignition module screws with blue
Loctite
®
242.
• Holding gauge, rotate flywheel
magnets around to coil.
• Torque ignition coil screws to 89-105
in/lbs (10 - 12 Nm).
• Remove gauge, rotate flywheel and
check for clearance.
• Connect stop switch cable.