![background image](http://html1.mh-extra.com/html/ics/695gc-f4/695gc-f4_service-manual_3553851003.webp)
©2012 ICS - Blount Inc, Specifications subject to change without notice. REV11272012 P/N 546529
3
695GC/F4 SERVICE MANUAL
SERVICE MANUAL USE
Service Manual Use
This manual contains all the technical information necessary for carrying out repairs on the
695GC/F4 saw. For safe, efficient work, it is of prime importance that the values indicated be
adhered to. Routine periodic maintenance is covered in the operator’s manual included with
each saw.
General Service Rules
• Always use the right tools for the job, otherwise components may be damaged.
• Use a plastic dead blow mallet to separate parts attached solidly to each other.
• Mark mating parts as a reassembly reference.
• Keep component parts together as a group. Assemble screws and nuts into appropriate
subgroups.
• When reassembling, clean all parts carefully, lubricate moving parts and replace all oil
seals, o-rings, gaskets, washers and self-locking nuts.
•
For best results, use only original ICS
®
replacement parts.
General Recommendations
• Some procedures in this manual require the use of special tools. These are noted in the
service manual.
• Detailed carburetor maintenance and overhaul information is available in Walbro’s
Diaphragm Carburetor Service Manual. Walbro can be contacted at http:\\www.walbro.com
or by calling 1.989.872.2131.