603GC OPERATOR’S MANUAL
10
© 2006 ICS, Blount Inc. P/N 518538 Jul 06
SET-UP
GUIDE BAR AND DIAMOND CHAIN INSTALLATION
STEP
Drive links should be in the bar groove but
not completely engaged.
STEP 9
Hold the guide bar nose up & manually pull
the chain across the top of the guide bar
away from the saw. See Note 1
STEP 8
The tensioning scrench should fit between
the guide bar and the chain drive links.
STEP 10
Continue to lift up on the nose of the guide
bar and firmly tighten the side cover nuts.
See Note 2.
Chain
Tension
Note 1: Do not “over tension” the diamond chain. Loss of power will result. It is normal for the
drivelinks to hang underneath the guide bar. The diamond chain should be snug but be able to be
pulled around the guide bar by hand.
Note 2: To prevent chain tensioner breakage, be sure the side cover nuts are tightened to
approximately 20 ft-lbs (2Nm).
Summary of Contents for 603GC
Page 1: ...2006 ICS Blount Inc P N 518538 Jul 06 603GC UTILITY GAS SAW OPERATOR S MANUAL...
Page 2: ......
Page 25: ......