603GC OPERATOR’S MANUAL
16
© 2006 ICS, Blount Inc. P/N 518538 Jul 06
MAINTENANCE
Follow these simple maintenance guidelines
and your saw will keep running at its very best.
AFTER EACH USE
1. Rinse the saw, guide bar and diamond chain with water.
2. Follow instructions on the Daily Maintenance Label, located on the air filter cover.
3. Inspect and tighten all fasteners as necessary.
. Inspect drive sprocket for tooth wear and replace if tooth tips are pointed.
5. Inspect the starter cord. Replace if frayed.
6. Inspect the air filter for holes and debris. Replace as necessary.
. Spray saw, guide bar, and chain with lightweight oil.
8. Grease the chain tensioner.
AFTER 10 HOURS OF USE
1. Remove the starter cover and lubricate the starter recoil spring. Clean the flywheel fins and the
starter pawls with a wire brush, then grease the starter pawls.
2. Remove the spark plug and clean with a wire brush. Check the electrode gap. The correct gap is
0.020 inches (0.5mm).
AFTER 40 HOURS OF USE
1. Change the spark plug. Adjust the electrode to 0.020 inches (0.5mm).
2. Check the fuel filter located inside the fuel tank. Clean or replace if clogged
Summary of Contents for 603GC
Page 1: ...2006 ICS Blount Inc P N 518538 Jul 06 603GC UTILITY GAS SAW OPERATOR S MANUAL...
Page 2: ......
Page 25: ......