ROCKY-3705EV-R2 Socket 370 Celeron
TM
, Pentium III
®
& Tualatin Processor with Ethernet , VGA , Audio Board
53
Video Off Option
When enabled, this feature allows the VGA adapter to operate in a power saving
mode.
Always On
Monitor will remain on during power saving modes.
Suspend --> Off Monitor blanked when the systems enters the Suspend
mode.
Susp,Stby -->
Off
Monitor blanked when the system enters either Suspend or
Standby modes.
All Modes -->
Off
Monitor blanked when the system enters any power saving
mode.
Video Off Method
This determines the manner in which the monitor is blanked.
V/H
SYNC+Blank
This selection will cause the system to turn off the vertical
and horizontal synchronization ports and write blanks to the
video buffer.
Blank Screen
This option only writes blanks to the video buffer.
DPMS
Select this option if your monitor supports the Display
Power Management Signaling (DPMS) standard of the
Video Electronics Standards to select video power
management values.
Switch Function
You can choose whether or not to permit your system to enter complete Suspend
mode. Suspend mode offers greater power savings, with a correspondingly
longer awakening period..
The choice: Break/Wake, Disabled.
ROCKY-3705EV-R2 Socket 370 Celeron
TM
, Pentium III
®
& Tualatin Processor with Ethernet , VGA , Audio Board
54
Hot Key Function As
Select
Enabled
if your system has a hot key for soft power off.
The choice: Enabled, Disabled.
HDD Off After
By default, this item is Disabled, meaning that no matter the mode the rest of the
system, the hard drive will remain ready. Otherwise, you have a range of choices
from 1 to 15 minutes or Suspend. This means that you can elect to have your
hard disk drive be turned off after a selected number of minutes or when the rest
of the system goes into a Suspend mode.
Power Button Over Ride
You could press the power button for more than 4 seconds forces the system to
enter the Soft-Off state when the system has “hung.”
The choice: Soft-Off, Delay 4 Sec.
PM Wake Up Events
IRQ [3-7,9-15],NMI
The following is a list of IRQ’s,
I
nterrupt
R
e
Q
uests, which can be exempted much
as the COM ports and LPT ports above can. When an I/O device wants to gain
the attention of the operating system, it signals this by causing an IRQ to occur.
When the operating system is ready to respond to the request, it interrupts itself
and performs the service.
As above, the choices are
On
and
Off.
When set
On
, activity will neither prevent the system from going into a power
management mode nor awaken it.
•
IRQ [ 3-7, 9-15], NMI
•
IRQ 8 Break Suspend :
You can
Enable
or
Disable
monitoring of IRQ8 (the
Real Time Clock) so it does not awaken the system from Suspend mode.
