P7
5
Boot Steps
A.
Please confirm the CT is locked into the module, and “Ext_Bus” is
connected an extension module by audio line. (If there is no extension
module, the “Ext_Bus” don’t be connected.)
B.
Adjusting DIP switch and set the parameter of communication, and
switch “PWR” to OFF. And then switch “PWR” to ON after press
“Wake” and “Boot” buttons for 5 seconds.
C.
When power on, if “STA” will light on for 1 second and off, this mean
boot complete. If “STA” do not be lighted, please press “Boot” for 1~3
seconds, and confirm “STA” will light on for 1 second and off. Finally,
press “Wake” once, confirm “STA” blink once to complete the boot.
D.
Connect the CT to the cable to be measured. The buckle has no
directionality, but after the buckle, you must confirm that the opening
is completely closed.
○
A
○
B
○
D
○
C
Before the CT
be buckled
After the CT
be buckled
Confirm the opening is
completely closed
