ICP DAS USA ISaGRAF WinCE ViewPAC, User Manual

Page: 70 / 192

ISaGRAF WinCE ViewPAC User Manual , V.1.6 , 1/2017 by ICP DAS
4-20
4.3 Download & Debug The Example Project
We have two ways to download the project to the ISaGRAF WinCE ViewPAC. One is using Ethernet cable,
the other one is using RS-232 cable. Here will show you the RS-232 way. (
Please refer to section 3.2.3 if
you would like to download the project via Ethernet )
Hardware Wiring
The RS-232 cable wiring should be as below figure. ( Please make sure the “Modbus RTU Slave Port” is
set as COM3 (refer to Appendix A.2 , or it can only be download via Ethernet )
This section lists how to download the ISaGRAF program via RS-232 cable. However user may also use
Ethernet cable to download program to the VP-2xW7/4xx7 (please refer to
section 3.2.3 )
Link Setup
Click on the "Link Setup" icon in the "ISaGRAF Programs" window. When you click on the "Link Setup"
icon, the following window will appear. Please set the proper value.
COM3
PC (9-Pin DSUB) VP-2xW7/4xx7 (COM3: RS-232)
2 RxD
3 TxD
5 GND 2 RxD
3 TxD
5 GND
Net-ID of the ViewPAC. Default is 1
COMM port of your PC
Click on it to set COMM’s other
parameter
COMM’s parameter, default is 19200, N, 8, 1, No
flow control