iCAM-
721F User’s Manual ICP DAS
71
GPIO Input:
On the defined days of the week and at certain time of the set
days, the Camera will trigger its GPIO Input Signal according to the set
time interval (in seconds) when its state changes.
The user can select “Single snapshot” or “6 snapshot” with 1 or 2
seconds interval (3 frames before and 3 frames after motion frame).
Target:
The stream of accumulated snapshots may be stored in the
SD Card, sent to host by E-mail or FTP, activated GPIO Output Port
as preferred, or through all of them.
The stream of accumulated snapshots may be sent to host through E-mail, FTP,
stored in the SD card, Remote Disk, activated GPIO Output Port; per selection
or through all of them. When selected, the setup dialog for these methods will
display is illustrated in the following figure.
