iCAM-
721F User’s Manual ICP DAS
87
5.2 How to let camera to do Hardware Reset
In some cases, such as user forget login username & password they’ve changed
before; or modify some settings to cause camera displayed image improperly; or
camera system is no response & hang to the user’s operation… etc., you may
need to let camera to do Hardware Reset. After that, camera could reboot,
operate and re-configure. The default iCAM setting after reset:
IP: 192.168.255.2
(Default Username/Password: admin/admin)
Submask: 255.255.0.0
Gateway address: 192.168.0.1
DNS Server address: 8.8.8.8
The hardware reset steps
are as the following:
1)
Please make sure camera is power on first.
2)
Refer the below
GPIO Port
pin definition table of the cable; connect
Default Setting(5)
and
GND(4)
pins to short, remove the connection 10
seconds later.
