ICP DAS USA HRT-710, User Manual

Page: 53 / 104

HRT-710 User Manual (Version 1.24, June/2015) PAGE: 53
Warning: If enables this function, just supports HART
―Point to
Point
‖ mode.
(3) Frame type : Short or Long frame.
(4) Master type : Primary or Secondary Master.
Warning: In general, HRT-710 should be the
―Primary Master‖.
(5) Network mode :
―Point to Point‖ or ―Multi-drop‖ mode.
Warning: I
(1)
―Point to Point‖
: Only one HART slave device in HART bus.
(2)
―Multi-drop‖
: More than one HART devices can be in HART bus.
(6) Address : 0~15.
Warning: If the address of HART device is 0, it means in
―Point to
Point
‖ mode.
(7) Preambles : 5~20.
(8) Get identifier automatically : If the frame type of HART slave device
is long frame, users can enable this function to get unique ID
automatically by short frame address.
(9) Manufacturer ID: Users can set the manufacturer ID for HART
device. If the frame type is ―short‖, users can omits this setting.
(10) Device type : Users can set the device type for HART device. If
the frame type is ―short‖, users can omits this setting.
(11) Device ID : Users can set the device ID for HART device. If the
frame type is ―short‖, users can omits this setting.
(12) Cmd 0 mode
: Disable / Initial / Polling.
(13) Cmd 3 mode : Disable / Initial / Polling.
Disable: HRT-710 will not execute the default HART Cmd.
Initial: HRT-710 will execute the default HART Cmd automatically
when in
―Initial‖ mode.
Polling: HRT-710 will execute the default HART Cmd
automatically when in
―Operation‖ mode.