5. Insert the Roller (38) on the Left Pedal Arm (32)
and the Roller on the Right Pedal Arm (33) into
the sides of the Ramp (5).
Attach the Rear Ramp Cover (7) to the
Ramp (5) with two M4 x 16mm Screws (116).
See the inset drawing.
Lift the Pedal Arm
Latch (41) on the Left Pedal Arm (32) and set
the end of the Left Pedal Arm on the left Crank
Bushing Sleeve (54). Release the Pedal Arm
Latch;
make sure that the Left Pedal Arm is
securely connected to the Crank Bushing
Sleeve.
Connect the Right Pedal Arm (33) to the
right Crank Bushing Sleeve (not shown) in
the same way.
8
116
7
5
5
41
54
32
38
32
33
6
65
64
107
101
101
1
10
Avoid pinching the
Wire Harnesses
(64, 65)
107
6. While another person holds the Upright (10)
near the Frame (1), connect the Upper Wire
Harness (65) to the Lower Wire Harness (64).
Tip: Avoid pinching the Wire Harnesses (64,
65).
Carefully insert the Upright (10) into the
Frame (1). Attach the Upright with four M8 x
20mm Patch Screws (107) and four M8 Split
Washers (101).
