29
MAINTENANCE
Regular maintenance is important for optimal
performance and to reduce wear. Inspect and properly
tighten all parts each time the trainer is used. Replace
any worn parts immediately.
To clean the trainer, use a damp cloth and a small
amount of mild soap. IMPORTANT: To avoid damage
to the console, keep liquids away from the console
and keep the console out of direct sunlight.
CONSOLE TROUBLESHOOTING
If the console does not turn on, make sure that the
power adapter is fully plugged in.
If the console does not display your heart rate when
you hold the handgrip heart rate monitor, or if the dis-
played heart rate appears to be too high or too low, see
step 5 on page 21.
If a replacement power adapter is needed, call the
telephone number on the cover of this manual.
IMPORTANT: To avoid damaging the console, use
only a manufacturer-supplied regulated power
adapter.
If the console does not boot
up properly, or if the con-
sole freezes and does not
respond, reset the console
to the factory default set-
tings. IMPORTANT: Doing
this will erase all custom settings you have made
to the console. Resetting the console requires two
people. First, unplug the power adapter. Next, locate
the small reset opening (A) on the back or the side of
the console. Using a bent paper clip, press and hold
the reset button inside the opening, and have a second
person plug in the power adapter. Continue holding the
reset button until the console turns on. When the reset
operation is complete, the console will turn off and then
turn back on. If it does not, unplug and then plug in the
power adapter. Once the console turns on, check for
firmware updates (see step 5 on page 26). Note: It
may take a few minutes for the console to be ready for
use.
HOW TO ADJUST THE REED SWITCH
If the console does not display correct feedback, the
reed switch should be adjusted. To adjust the reed
switch, first unplug the power adapter.
Next, remove the
four indicated
M4 x 16mm
Screws (93) and
the Center Shield
Cover (31).
Next, turn the Crank Pulley (44) until a Pulley Magnet
(99) is aligned with the Reed Switch (60). Then, slightly
loosen the two M4 x 12mm Flange Screws (94), slide
the Reed Switch slightly closer to or away from the
Pulley Magnet, and retighten the Flange Screws.
Then, plug in the power adapter and turn the Crank
Pulley (44) for a moment. Repeat these actions, if
necessary, until the console displays correct feedback.
Then, reattach the center shield cover.
A
93
31
44
60
99
94
MAINTENANCE AND TROUBLESHOOTING