![background image](http://html1.mh-extra.com/html/icon-health-and-fitness/ntex02422-int-3/ntex02422-int-3_user-manual_3469961010.webp)
10
Note: This drawing is scaled to 94% compared to the
other assembly drawings and to the exploded drawing.
Note: This drawing is scaled to 94% compared to the
other assembly drawings and to the exploded drawing.
Note: This drawing is scaled to 94% compared to the
other assembly drawings and to the exploded drawing.
7. Have a second person hold the Console
(10) near the Console Bracket (11). Then,
route the wires (F) on the back of the
Console through the opening in the Console
Bracket as shown by the dashed line at the right.
See inset drawing a.
Connect the wires (D)
from the Console Support (8) to the match-
ing wires (F) on the back of the Console (10).
Tip: The wire connectors should slide
together easily and snap into place with an
audible click. If they do not, turn one connec-
tor and try again.
Tip: Avoid pinching the wires (F, D). If
necessary, adjust the tilt of the Console
Bracket (11) to make this step easier.
Attach
the Console (10) to the Console Bracket with
four M6 x 20mm Machine Screws (102);
start all
the Machine Screws, and then tighten them.
Tilt the Console (10) upward and downward
a few times.
If the up and down movement
feels too loose, see inset drawing b.
Tighten
the four M6 x 15mm Cap Screws (157) in the
Rear Bracket Mount (114) until the up and down
movement no longer feels loose. Tilt the Console
upward and downward to access the Cap
Screws. Note: For clarity, the Console and the
wires are not shown.
11
10
10
102
102
157 114
D
F
F
8
8
Avoid pinching
the wires (F, D)
7
a
b
157