11
143
143
7
8
Avoid pinching
the wires
24
25
14
16
16
16
40
40
44
44
37
38
13
119
138
8. See the inset drawing. Identify a Handlebar
Cover (40) and the Right Rear Leg Cover (44),
and slide them onto a Handlebar (16) as shown.
Tip: Avoid pinching the wires. Insert the
Handlebar (16) into the Right Pivot Leg (13), and
attach it with two M10 x 45mm Bolts (119) and
two M10 x 18mm Washers (138).
Tip: Avoid pinching the wires. Press the Right
Rear Leg Cover (44) into the Pivot Covers A and
B (37, 38). Then, press the Handlebar Cover
(40) into place.
Repeat this step on the other side of the
elliptical.
7. Identify the Left and Right Rear Belt Covers
(24, 25), and then attach them to the Left Pedal
Arm (14) with five M4 x 16mm Screws (143);
start all the Screws, and then tighten them.
Repeat this step on the other side of the
elliptical.
