9
6. Identify the Left and Right Base Covers (92, 93).
Slide the Left Base Cover onto the Left Upright
(89). Slide the Right Base Cover onto the Right
Upright (90).
Do not press the Base Covers
into place yet.
89
92
90
93
6
5. Hold the Left Upright (89) against the Base (97).
Be careful not to pinch the wires.
If necessary,
position the base ground wire (A) in the hole in
the side of the Left Upright.
Insert two 3/8" x 2 3/4" Screws (7) and two 3/8"
x 1 1/4" Screws (8) with two 3/8" Star Washers
(12) into the Left Upright (89). Note: It may be
helpful to put the head of the Screw that goes
into the indicated hole on the end of the hex key
(C) and then insert it into the hole.
Partially tighten the 3/8" x 2 3/4" Screws (7) and
the 3/8" x 1 1/4" Screws (8) until the heads of
the Screws touch the Left Upright (89);
do not
fully tighten the Screws yet.
Note: It may be
helpful to use the short hex key (D) on the Screw
shown.
Attach the Right Upright (not shown) in the
same way.
89
97
5
8
7
12
A
12
D
Hole
C