![background image](http://html1.mh-extra.com/html/icom/ic-v8/ic-v8_instruction-manual_2038138026.webp)
42
10
PAGER/CODE SQUELCH
• Receive accept/receive inhibit
➥
“Receive accept” (“SKIP” indicator does not appear) accepts
pager calls when the transceiver receives a signal with a code
the same as that in the code channel.
➥
“Receive inhibit” (“SKIP” indicator appears) rejects calls even
when the transceiver receives a code the same as that in the
code channel. Transmit codes should therefore be programmed
for “receive inhibit,” otherwise the transceiver will not reject un-
necessary calls.
• Pager/code squelch operation during channel indication
To use these functions in channel indication, the pager/code
squelch setting must be programmed with other memory contents
before selecting channel number indication.
41
10
PAGER/CODE SQUELCH
D
D
Code programming
An ID code MUST be programmed into code channel C0. Up to 6
transmit codes are programmable into code channels, C1 to C6, if
required.
q
Push [
✱
•
OPTION
] after [A•
FUNC
] is pushed.
• Pager mode is selected.
• 100 MHz digit shows “P.”
w
Push [8•
SET
] after [A•
FUNC
] is pushed.
• One of “CP” or “C0” to “C6” flashes.
• “C0” is the ID code and “C1” to “C6” are
transmit code.
e
Rotate [VOL] to select code channel C0.
• A different ID code must be programmed into each transceiver.
r
Enter the desired 3-digit ID code via the
keypad.
t
Rotate [VOL] to select a transmit code
channel from C1 to C6.
y
Enter the desired 3-digit transmit code via
the keypad.
u
Push [6•
SKIP
] after [A•
FUNC
] is pushed to
set the channel for “receive inhibit” or “re-
ceive accept.”
• When “receive inhibit” is set, “SKIP” ap-
pears as at right.
• Code channel C0 cannot be set as “receive inhibit.”
• See the following table for “receive accept” and “receive inhibit” de-
tails.
i
Repeat steps
t
and
y
to set additional transmit code channels,
if desired.
o
Push [#•
ENT
] or [PTT] to exit code set mode.
MR
F
TX
MR
F
TX
MR
F
TX
MR
F
TX
SKIP
MR
F
TX