![background image](http://html1.mh-extra.com/html/icom/ic-p7a/ic-p7a_instruction-manual_2038061015.webp)
2
1
PANEL DESCRIPTION
1
y
CALL•MODE•SCAN KEY [CALL] (
MODE
•
SCAN
)
➥
Push momentarily to select the call channel. (p. 12)
➥
Push and hold for 1 sec. to enter the scan type selection
condition, push again to start a scan. (p. 35)
➥
While pushing and holding
[FUNC]
, push momentarily
to select the operating mode. (p. 14)
➥
While pushing and holding
[FUNC]
, push and hold for
1 sec. to start a tone scan. (p. 48)
u
VFO/MEMORY•MEMORY WRITE KEY [V/M] (
SKIP
•
S
.
MW
)
➥
Push momentarily to toggle between VFO and
memory
mode
. (p. 9)
➥
Push and hold for 1 sec. to enter
select memory write
mode
. (p. 24)
➥
While pushing and holding
[FUNC]
, push momentarily
to select scan skip condition. (p. 40)
➥
During VFO scan, pushing and holding
[FUNC]
, push
and hold for 1 sec. to store into highest blank memory
channel as PSKIP channel (p. 40)
i
SQUELCH•ATTENUATOR•SET KEY [SQL] (
ATT
•
SET
)
➥
Push and hold to open the squelch temporarily and
monitor the operating frequency. (p. 15)
➥
While pushing and holding this key, rotate
[DIAL]
* to ad-
just the squelch level. (p. 14)
➥
While pushing and holding
[FUNC]
, push and hold for
1 sec. to enter
set mode
. (p. 49)
o
POWER KEY [PWR]
Push and hold for 1 sec. to turn the transceiver power ON
and OFF.
!0
BAND•TUNING STEP•LOCK KEY [BAND] (
TS
•
LOCK
)
➥
Push to select the operating frequency band. (p. 9)
➥
While pushing and holding
[FUNC]
, push momentarily
to enter
tuning step set mode
. (p. 11)
➥
While pushing and holding
[FUNC]
, push and hold for
1 sec. to toggle the lock function ON and OFF. (p. 18)
!1
TX RX INDICATOR [TX/RX] (
pgs. 13, 16)
Lights green while receiving a signal or when the squelch
is open; lights red while transmitting.
!2
CONTROL DIAL [DIAL]
➥
Rotate to select the operating frequency.* (p. 11)
➥
While scanning, changes the scanning direction.*
(p. 35)
➥
While pushing and holding
[SQL] (
ATT
•
SET
)
, sets the
squelch level.* (p. 14)
➥
While pushing and holding
[FUNC]
, changes the oper-
ating frequency in 100 kHz, 1 MHz or 10 MHz incre-
ments in
VFO mode
.* (p. 11)
➥
While pushing and holding
[FUNC]
, changes the mem-
ory channel in 10 channels steps in
memory mode
.*
(p. 12)
➥
While pushing and holding
[BAND] (
TS
•
LOCK
)
, selects
the operating band in
VFO mode
.* (p. 9)
➥
While pushing and holding
[BAND] (
TS
•
LOCK
)
, selects
the programmed bank or auto memory write channel in
memory mode
.* (p. 9)