■
Transmitting a call (Continued)
D
Direct code entry
q
While in the standby condition, push [TX Code Enter] to enter
the TX code edit mode.
• Editable code digit blinks.
w
Push [TX Code Enter] to select the desired digit to be edited.
• Editable digit differs according to the setting.
e
Set the desired digit using [
]/[
]/[TX Code CH Up]/[TX
Code CH Down].
r
Push [TX Code Enter] to set the digit. The editable digit will
move to the right automatically.
t
Repeat
e
and
r
to input all allowable digits.
y
Push [P0] (Call) or [PTT]* to call.
* PTT call can be made only when PTT call capability is permitted.
NOTE:
When no answer back is received, the transceiver re-
peats the call 3 times (default) automatically, and “
”
is
displayed during each call. However, an error beep sounds
and “
”
is displayed when no answer back is received
after the calls.
u
Push [PTT] to transmit; release to receive.
i
Push [P3] (Moni(Audi)) to send the “Clear down” signal.
For your information
When the “UpDate” setting for the call code is enabled, the set
code is overwritten into the call code memory.
25
4
BIIS OPERATION
Summary of Contents for IC-F51
Page 1: ...INSTRUCTION MANUAL UHF TRANSCEIVER iF61 L P0 P1 P2 P3 ...
Page 62: ...MEMO ...
Page 63: ...MEMO ...
