![background image](http://html1.mh-extra.com/html/icom/ic-f3100d-series/ic-f3100d-series_instruction-manual_4262720021.webp)
12
BASIC OPERATION
2
3
■
Turning power ON
Prior to using the transceiver for the first
time, the battery pack must be fully charged
for optimum life and operation. (p. 31)
➥
Rotate [VOL] to turn power ON.
D
Battery type selection
The battery type must be selected according to the battery pack or
case when it is changed, but only the first time it is used.
Check the battery type before you begin the selection procedure.
One to three beep(s) sound in sequence, so you must repeat the
steps until the number of beeps matches your battery type.
For example, if your battery type is a Li-ion battery pack, you must
repeat the procedure until one beep is heard.
q
Set [ROTARY SELECTOR] to any
channel other than Channel 16.
w
Rotate [VOL] to turn OFF the trans-
ceiver’s power.
e
While holding down [PTT], rotate
[VOL] to turn ON the power.
• You should hold [PTT] until the bat-
tery type confirmation beeps sound.
(It takes approximately 5 seconds;
while holding down [PTT], the count
down beeps sound. After that, the confirmation beeps sound.)
• One beep sounds when the Li-ion battery is selected.
• Two beeps sound when the battery case is selected.
• Three beeps sound when the Ni-MH battery is selected.
r
After the beep sounds, release [PTT].
t
Repeat steps
w
to
r
until you select the attached battery type.
NOTE: This operation may not be available, depending on the
presetting. Ask your dealer for details.
[VOL]
[VOL]
[PTT]
[ROTARY SELECTOR]
3
Summary of Contents for IC-F3100D series
Page 62: ...MEMO...
Page 63: ...MEMO...