![background image](http://html1.mh-extra.com/html/icom/ic-f1710/ic-f1710_instruction-manual_4221796021.webp)
17
3
BIIS OPERATION
3
ï
Direct code entry
q
While in the standby condition, push [P3] (TX Code Enter)
to enter the TX code edit mode.
• Code digit for editing blinks.
0 5 0 0
w
Push [P3] (TX Code Enter) to select the desired digit to
be edited.
• Digit for editing differs according to the setting.
e
Set the desired digit using [CH Up]/[CH Down]/[DIAL] or
10-keypad*.
*IC-F1810 or IC-F2810 only
r
Push [P3] (TX Code Enter) to set the digit, then the digit to
the right will blink automatically.
• When the 10-keypad is used for setting, the digit to the right will
blink automatically without pushing [P3] (TX Code Enter).
t
Repeat
e
and
r
to input all allowable digits.
y
Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE:
When no answer back is received, the transceiver
repeats the call 3 times (default) automatically, and
“
WAIT
”
is displayed during each call. However, an error beep
sounds and
“
FAILED
”
is displayed when no answer back
is received after the calls.
u
Push [PTT] to transmit; release to receive.
i
Push [P4] (Moni(Audi)) to send the ‘Clear down’ signal.
For your information
When the “UpDate” setting for the call code is enabled, the set
code is overwritten into the call code memory.