![background image](http://html2.mh-extra.com/html/icom/ic-f1100d-series/ic-f1100d-series_operating-manual_4194283041.webp)
5
NXDN™ OPERATION
5-6
Previous view
D
Transmitting a Status message
You can transmit a preset simple message� You
cannot transmit a voice signal at the same time�
<For the Simple key and Ten-key types>
1� Push [Digital Button] to enter the Application
selection mode�
•According to the current call type, “INDIV” (Individual
call) or “GROUP” (Group call) is briefly displayed, and
then “VOICE” is displayed�
L
If you want to change the call type, hold down [Digital
Button] for 1 second in the Standby mode�
2� Push [CH Up] or [CH Down] to select “STATUS,”
and then push [Digital Button]�
3� Push [CH Up] or [CH Down] to select a status, and
then push [Digital Button]�
4� Push [CH Up] or [CH Down] to select an Individual
station or a Group�
5� Push [PTT] to transmit a Status message�
• “STAT OK” is displayed when an acknowledgment is
received from the targeted station�
• “STA FAIL ” is displayed if an acknowledgment is not
received from the targeted station�
TIP:
•Hold down [Status] for 1 second to transmit the preset
Status message�
•For the Ten-key type, push a numeric key [0] ~ [9] to
directly select the preset Status message to the latest
transmitted station or group�
•Hold down a numeric key [0] ~ [9] to directly send the
preset Status message to the latest transmitted station or
group�
Transmitting a call
NOTE:
If the following settings are configured using
the CS-F2100D
programming
software
,
the Status
message can be automatically transmitted when:
•The transceiver is turned ON or OFF
L
Set the Status message to be transmitted in
Power ON
Status
or
Power OFF Status
, respectively�
L
Set the target station ID in
Power Status ID for
Conventional
or
Power Status ID for Single-site
Trunk
�
( Digital > Status >
Status Setting
)
• After sending a voice message
L
Set
Send with Voice Call
to “Enable�”
L
Set the Status message to be transmitted in
Send
Status Number
�
( Digital > Status >
Status Setting
)
<For the Non-display type>
A Status call can be transmitted by pushing [Status]�
1� Rotate [Rotary Selector] to select a Status�
2� Hold down [Status] to transmit a Status call�