13
CONNECTOR INFORMATION
13-6
X-VERTER
Outputs HF frequency signals for the
Transverter operation.
•
Input/Output impedance: 50 Ω (unbalanced)
•Output signal level:
More than –20 dBm
L
Set the “Transverter Function” item to ON to use the
transverter operating mode.
MENU
» SET > Function >
Transverter Function
• You cannot select the antenna or use the internal
antenna tuner while the Transverter function is
ON.
L
Set the offset frequency for the transverter
operation.
MENU
» SET > Function >
Transverter Offset
ANT 1 / ANT 2
Connect a 50 Ω antenna for the HF to 50 MHz
frequency band.
•
Input/Output impedance: 50 Ω (unbalanced)
L
If you are using the AH-4, connect it to [ANT 1].
RX-ANT IN/OUT
Connect a receive antenna to
[RX-ANT IN], and a receiver to
[RX-ANT OUT].
•
Input/Output impedance: 50 Ω (unbalanced)
•Connector type:
BNC
L
Signal is directly received through [RX-ANT IN],
instead of the antenna connector.
You can also connect an external preamp or filter, as
shown below.
L
In this case, set the antenna connector to “ANT 1/R”
or “ANT 2/R.” (p. 7-1)
IN
[RX-ANT]
[ANT 2]
[ANT 1]
OUT
TX
RX
Filter
MAIN receiver
SUB receiver
Transmitter
Example
