10
3
BASIC OPERATION
■
Turning power ON
Hold down
q
for 2 seconds to turn the power ON.
If the transceiver is programmed with a start-up
w
password, the screen as described below is displayed.
Enter the password digits using [
➥
] and [
].
To select the digit to edit, push [
➥
] and [
].
When the password is entered, push [
➥
].
If the “Password” screen does not clear after entering
➥
the digits, the numbers may be incorrect.
■
Adjusting the volume
Push
or
to adjust the audio level. (0 to 32)
• “ ” appears when the audio level is set to 0 (silent mode).
■
Selecting a channel
➥
Push [
] or [
] to select the desired channel.
• Holding down [
] or [
] continuously changes the displayed
channel until channel 1 is selected.
• When channel 1 is selected, beeps sound.
• “CB CH” is displayed when a CB channel is selected, “Repeater
CH” is displayed when a repeater channel is selected, and
“Receive CH” is displayed when a receive channel is select.
Summary of Contents for IC-450
