53
11
PAGER/CODE SQUELCH
D
D
Code programming
An ID code
MUST
be programmed into code channel C0. Up
to 6 transmit codes are programmable into code channels, C1
to C6, if required.
q
Push
[BANK
]
for 1 sec. then rotate
[DIAL]
to turn
Pager mode ON.
• “PG” appears.
w
Push
[SET]
or
[MONI]
.
• One of either “CP” or “C0” to “C6” flashes.
• “C0” is the ID code and “C1” to “C6” are transmit codes.
e
Rotate
[DIAL]
to select code channel C0.
• A different ID code must be programmed into each transceiver.
r
Push
[MONI]
(or
[SET]
) to set into code programming condi-
tion.
• The 1st digit blinks and “C0” indication stops blinking.
t
Rotate
[DIAL]
to set the desired code.
y
Push
[MONI]
(or
[SET]
)
to select 2nd digit, then rotate
[DIAL]
to set the desired code.
• 2nd digit blinks (1st digit stop blinking).
• Repeat this step for 3rd digit programming.
u
Push
[MONI]
(or
[SET]
) to program the ID code.
• Long beep sounds and the “C0” indication blinks.
i
Rotate
[DIAL]
to select a transmit code channel from “C1”
to “C6.”
o
Repeat steps
r
to
u
to set transmit code channel.
!0
Push
[S.MW
]
to set the channel for “receive inhibit”
or “receive accept.”
• When “receive inhibit” is set, “SKIP” appears as follows.
• Code channel C0 cannot be set as “receive inhibit.”
• See p. 54 for “receive accept” and “receive inhibit” details.
!1
Push any key other than indicated function keys to exit code
set mode.
LOCK
SET
ANM
MONI
DUP
LOW
T-SCAN
TONE
PRIO
M/CALL
SCAN
V/ MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
Appears when “receive inhibit”
is set to the code channel.
MW
LOCK
SET
ANM
MONI
DUP
LOW
T-SCAN
TONE
PRIO
M/CALL
SCAN
V/ MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK
SET
ANM
MONI
DUP
LOW
T-SCAN
TONE
PRIO
M/CALL
SCAN
V/ MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
LOCK
SET
ANM
MONI
DUP
LOW
T-SCAN
TONE
PRIO
M/CALL
SCAN
V/ MHz
DIGITAL PRIO AO BUSY
MUTE
NAR
MID
LOW
OPT
Summary of Contents for IC-2200H
Page 2: ......