![background image](http://html1.mh-extra.com/html/icom/i7200/i7200_instruction-manual_611946074.webp)
69
9
ANTENNA TUNER OPERATION
■
Optional AH-4
automatic
antenna
tuner
operation
The AH-4 matches the IC-7200 to a long wire antenna
more than 7 m/23 ft long (3.5 MHz and above).
• See p. 14 for connection.
• See the AH-4 instruction manual for AH-4 installation and
antenna connection details.
AH-4 setting example:
For mobile operation
For outdoor operation
Long wire
Optional AH-2b
antenna element
R
DANGER!: HIGH VOLTAGE!
NEVER
touch the antenna element while tuning or
transmitting.
NEVER
operate the AH-4 without an antenna wire.
The tuner and transceiver will be damaged.
NEVER
operate the AH-4 when it is ungrounded.
Transmitting before tuning may damage the trans-
ceiver. Note that the AH-4 cannot tune when using a
1
⁄
2
λ
long wire or on a multiple of that frequency.
D
AH-4 operation
Tuning is required for each frequency.
Be sure
to
re-tune the antenna before transmitting when you
change the frequency—even slightly.
q
Set the desired frequency in an HF band.
• The AH-4 will not operate on frequencies outside of
ham bands.
w
Push and hold
TUNER
for 1 sec.
• “
” indicator blinks while tuning.
e
“
”
indicator is still ON after the tuning is
completed.
• When the connected wire cannot be tuned, “
”
indicator goes out, and the AH-4 is bypassed and the
antenna wire is connected to the antenna connector
on the transceiver directly.
r
To bypass the AH-4 manually, push
TUNER
.
• “
” indicator goes out.
Appears when the antenna tuner ON.
Blinks while tuning.
CONVENIENT
• PTT tune function
(p. 76)
The AH-4 is always tuned when [PTT] is pushed
after the frequency is changed (more than 1%). This
function removes the “push and hold
TUNER
” op-
eration and activates first transmission on the new
frequency.
This function is turned ON in the set mode.