Thank you for choosing the IC-F1000D series
vhf
digital
transceivers
or IC-F2000D series
uhf
digital
transceivers
.
READ ALL PRECAUTIONS
carefully and
completely before using the transceiver.
1-1-32 Kamiminami, Hirano-ku, Osaka 547-0003, Japan
A-7206H-1EX
Printed in Japan
© 2015 Icom Inc.
EXPLICIT DEFINITIONS
WORD
DEFINITION
R
DANGER!
Personal death, serious injury or an explosion may occur.
R
WARNING!
Personal injury, fire hazard or electric shock may occur.
CAUTION
Equipment damage may occur.
NOTE
If disregarded, inconvenience only. No risk of personal injury, fire or electric shock.
PRECAUTIONS
PRECAUTIONS
VHF DIGITAL TRANSCEIVERS
Iç-F2000D
series
UHF DIGITAL TRANSCEIVERS
Iç-F1000D
series
R
DANGER! NEVER
short the terminals of the battery pack.
R
DANGER!
Use and charge only specified Icom battery
packs with Icom radios or Icom chargers. Only Icom
battery packs are tested and approved for use with Icom
radios or charged with Icom chargers. Using third-party or
counterfeit battery packs or chargers may cause smoke,
fire, or cause the battery to burst.
R
WARNING! NEVER
hold the radio that the antenna
is very close to, or touching exposed parts of the body,
especially the face or eyes, while transmitting. The radio
will perform best if the microphone is 5 to 10 cm (2 to 4
inches) away from the lips and the radio is vertical.
R
WARNING! NEVER
operate the radio with a headset
or other audio accessories at high volume levels. The
continuous high volume operation may cause a ringing in
your ears. If you experience a ringing, reduce the volume
level or discontinue use.
R
WARNING! NEVER
operate the radio while driving a
vehicle. Safe driving requires your full attention—anything
less may result in an accident.
CAUTION: MAKE SURE
the flexible antenna, battery pack
and jack cover are securely attached to the radio, and that
the antenna and battery pack are dry before attachment.
Exposing the inside of the radio to dust or water will result
in serious damage to the radio.
DO NOT
operate the radio near unshielded electric blasting
caps or in an explosive atmosphere.
DO NOT
push [PTT] when you do not actually intend to
transmit.
DO NOT
use or place the radio in direct sunlight or in
areas with temperatures below –25°C (–13°F) or above
+55°C (+131°F): ETS version, below –30°C (–22°F) or
above +60°C (+140°F): TIA version. The basic operations,
transmission and reception of the radio are guaranteed
within the specified operating temperature range.
DO NOT
modify the radio. The specifications may
change and then not comply with the requirements of a
corresponded regulation. The radio warranty does not
cover any problems caused by unauthorized modification.
DO NOT
use harsh solvents such as benzine or alcohol
when cleaning, as they will damage the radio surfaces.
BE CAREFUL!
The radio will become hot when operating
it continuously for long periods of time.
BE CAREFUL!
The radio meets IP67* requirements
for dust-tight and waterproof protection. However, once
the radio has been dropped, dust-tight and waterproof
protection cannot be guaranteed because of possible
damage to the radio’s case or the waterproof seal.
* Only when the jack cover, the optional HM-168LWP, or
HM-171GPW
is attached.
Even when the radio power is OFF, a slight current still
flows in the circuits. Remove the battery pack from the
radio when not using it for a long time. Otherwise, the
installed battery pack will become exhausted, and will need
to be recharged or replaced.
MAKE SURE
to turn the radio power OFF before
connecting the supplied or optional equipment.
- 1 -
FCC INFORMATION
• FOR CLASS A UNINTENTIONAL RADIATORS:
This equipment has been tested and found to comply
with the limits for a Class A digital device, pursuant to
part 15 of the FCC Rules. These limits are designed
to provide reasonable protection against harmful
interference when the equipment is operated in a
commercial environment. This equipment generates,
uses, and can radiate radio frequency energy and,
if not installed and used in accordance with the
instruction manual, may cause harmful interference
to radio communications. Operation of this equipment
in a residential area is likely to cause harmful
interference in which case the user will be required to
correct the interference at his own expense.
CAUTION:
Changes or modifications to this transceiver, not
expressly approved by Icom Inc., could void your
authority to operate this transceiver under FCC
regulations.
This device complies with Part 15 of the FCC Rules.
Operation is subject to the condition that this device
does not cause harmful interference.
COUNTRY CODE LIST
ISO 3166-1
Country
Codes
Country
Codes
1
2
3
4
5
6
7
8
9
10
11
12
13
14
15
16
17
Austria
Belgium
Bulgaria
Croatia
Czech Republic
Cyprus
Denmark
Estonia
Finland
France
Germany
Greece
Hungary
Iceland
Ireland
Italy
Latvia
AT
BE
BG
HR
CZ
CY
DK
EE
FI
FR
DE
GR
HU
IS
IE
IT
LV
18
19
20
21
22
23
24
25
26
27
28
29
30
31
32
33
Liechtenstein
Lithuania
Luxembourg
Malta
Netherlands
Norway
Poland
Portugal
Romania
Slovakia
Slovenia
Spain
Sweden
Switzerland
Turkey
United Kingdom
LI
LT
LU
MT
NL
NO
PL
PT
RO
SK
SI
ES
SE
CH
TR
GB
< Intended Country of Use >
AT
FI
IT
PL
GB
RO
BE
FR
LV
PT
IS
TR
CY
DE
LT
SK
LI
HR
CZ
GR
LU
SI
NO
DK
HU
MT
ES
CH
EE
IE
NL
SE
BG
VOICE CODING TECHNOLOGY
The AMBE+2™ voice coding Technology embodied in this
product is protected by intellectual property rights including
patent rights, copyrights and trade secrets of Digital Voice
Systems, Inc. This voice coding Technology is licensed
solely for use within this Communications Equipment.
The user of this Technology is explicitly prohibited from
attempting to extract, remove, decompile, reverse engineer,
or disassemble the Object Code, or in any other way
convert the Object Code into a human-readable form. U.S.
Patent Nos.
#5,870,405, #5,826,222, #5,754,974, #5,701,390,
#5,715,365, #5,649,050, #5,630,011, #5,581,656,
#5,517,511, #5,491,772, #5,247,579, #5,226,084 and
#5,195,166.
RECOMMENDATION
CLEAN THE TRANSCEIVER THOROUGHLY WITH
FRESH WATER
after exposure to saltwater, and dry
it before operating. Otherwise, the transceiver's keys,
switches and controllers may become unusable due to salt
crystallization.
NOTE: DO NOT
submerge the transceiver in water if
there is any reason (one of the following) to suspect the
waterproof protection may not be effective.
When the transceiver has been dropped
•
•
When the transceiver’s case or the waterproof seal is
cracked or damaged
•
When the jack cover or the optional HM-168LWP, HM-
171GPW, HS-94LWP, or HS-95LWP is detached from the
transceiver
- 4 -
Icom, Icom Inc. and the Icom logo are registered trademarks of
Icom Incorporated (Japan) in Japan, the United States, the United
Kingdom, Germany, France, Spain, Russia, and/or other countries.
All other products or brands are registered trademarks or
trademarks of their respective holders.