■
Programming after selection
q
Select memory mode with [V/M].
w
Set the memory channel to be programmed with [DIAL].
• Rotate [DIAL] while pushing [FUNC] to select a memory bank
(A–H) or programmed scan edge channel.
• Non-programmed channels cannot be selected.
e
Push [V/M] to select VFO mode.
r
Set the desired frequency:
➥
Select the desired band with [
↔
].
➥
Set the frequency using [DIAL].
➥
Set other data (e.g. offset frequency, duplex direction,
tone squelch frequency, etc.), if required.
t
Push [V/M] for 2 sec. to program the selected channel.
• Keep pushing for 2 sec. or more to automatically select the next
memory channel, if desired.
■
Transferring memory
contents to another memory
q
Select memory mode with [V/M].
w
Select the memory channel to transfer with [DIAL].
• Rotate [DIAL] while pushing [FUNC] to select a memory bank
(A–H) or programmed scan edge channel.
e
Push [V/M] for 1 sec. to indicate memory channels.
• Do not hold [V/M] for more than 2 sec., otherwise the memory
channel contents will be transferred to VFO.
r
Rotate [DIAL] to select the channel to transfer to.
• Rotate [DIAL] while pushing [FUNC] to select a memory bank or
programmed scan edge channel.
• VFO (VF), as well as regular memory channels, can be trans-
ferred in this way.
t
Push [V/M] for 2 sec. to transfer.
15
5
MEMORY CHANNELS
FM
FM
S1 3 5 7 9
VOL
FM
146.340.000
M:A03
TS
15.0
S1 3 5 7 9
VOL
FM
146.340.000
M: VF
TS
15.0
FM
FUNC
S1 3 5 7 9
VOL
. .
M:A20
TS
.
S1 3 5 7 9
VOL
FM
146.340.000
M:A20
TS
15.0
for
1 sec.
Select memory
channel
for 2 sec.
blank
channel
V/M
SKIP
V/M
SKIP
V/M
SKIP
for bank
selection
for CH
selection
+
[EXAMPLE]: Transferring memory channel 3 (memory bank A) to 20 (memory bank A).
