![background image](http://html1.mh-extra.com/html/icom/c-f43gs/c-f43gs_instruction-manual_4248018023.webp)
19
4
BIIS OPERATION
D
D
Direct code entry
q
While in the standby condition, push [P3] (TX Code Enter)
to enter the TX code edit mode.
• Editable code digit blinks.
w
Push [P3] (TX Code Enter) to select the desired digit to be
edited.
• Editable digit differs according to the setting.
e
Set the desired digit using [CH Up]/[CH Down]/[TX Code
CH Up]/[TX Code CH Down] or 10-keypad.*
*Depending on version
r
Push [P3] (TX Code Enter) to set the digit, then the
editable digit will move to the right automatically.
• When the 10-keypad is used to set, the editable digit will move to
the right automatically without pushing [P3] (TX Code Enter).
t
Repeat
e
and
r
to input all allowable digits.
y
Push [P0] (Call) or [PTT]* to call.
*PTT call can be made only when PTT call capability is permitted.
NOTE:
When no answer back is received, the trans-
ceiver repeats the call 3 times (default) automatically,
and
“
”
is displayed during each call. However, an
error beep sounds and
“
”
is displayed when no
answer back is received after the calls.
u
Push [PTT] to transmit; release to receive.
i
Push [MONITOR] (Moni(Audi)) to send the ‘Clear down’
signal.
For your information
When the “UpDate” setting for the call code is enabled, the
set code is overwritten into the call code memory.
IC-F33_43GT_GS-1.qxd 04.6.4 3:43 PM Page 19 (1,1)