PIVOT-IR USER MANUAL
21
THE THERMAL IMAGER NEEDS SUFFICIENT TIME TO WARM-UP FOR THE MOST
ACCURATE TEMPERATURE MEASUREMENTS AND BEST IMAGE QUALITY.
THIS TIME CAN OFTEN VARY BY ENVIRONMENTAL CONDITIONS. IT IS BEST
TO WAIT A MINIMUM OF 10 MINUTES FOR THE DEVICE TO COMPLETELY
WARM-UP.
8-2 Power On/Off the Device
To power the device on, push and hold the Power button for 3 seconds. It takes
approximately 50 seconds for the head-up display to load and the camera to
begin taking measurements.
To power the device off, push and hold the Power button until the screen darkens.
8-3 Hibernation Mode
Push and release the Power button to power on/off the screen display. This
sends the device into hibernation mode. Placing the device in this standby
mode helps to conserve battery power. See Section 8-15-4 Power Management
Settings for more information.
AFTER POWERING OFF, WAIT TEN SECONDS BEFORE ATTEMPTING TO
POWER THE DEVICE ON AGAIN.
THE DEVICE AUTOMATICALLY POWERS OFF AFTER A SET AMOUNT OF TIME.
ADJUST THE SHUT OFF TIMING BY CHANGING THE POWER MANAGEMENT
SETTINGS. TO ADJUST POWER MANAGEMENT SETTINGS SEE SECTION 8-15-
4 POWER MANAGEMENT SETTINGS.
THE DEVICE AUTOMATICALLY POWER OFF AFTER A SET AMOUNT OF TIME.
ADJUST THE SHUT OFF TIMING BY CHANGING THE POWER MANAGEMENT
SETTINGS. TO ADJUST POWER MANAGEMENT SETTINGS SEE SECTION 8-15-
4 POWER MANAGEMENT SETTINGS.
