icetro ID-0450-AN, Installation & Service Manual

Page: 35 / 49

Hopper Cover Thumbscrews
(3 total)
Breaker Bar Agitator Assy
Ice Base Plate
Compressor Shield
Agitator Motor
1. Close the water supply and drain it by forced drain function (when FND is on, press the DOWN and MODE buttons
simultaneously for 3 seconds).
2. Dispense all ice in the Ice Hopper by using the Dispensing Lever on the front of the machine.
3. Set main power switch to OFF and remove power cord from outlet. Then remove the panels.
4. Separate the harness connected to the ice dispensing solenoid assembly, LED/UV light, primary bin switch and
agitator motor.
5. Remove the ice hopper cover by loosening the 3 thumbscrews.
6. Remove the breaker bar and agitator assembly by lifting them both up and out from their respective locations.
7. Remove the ice base plate by rotating it clockwise until you can push on one end, so it tilts to one side. Then lift
out.
8. Unscrew the 5 fixing screws to remove the splash shield over the compressor.
Removal and Replacement of Ice Hopper & Agitator Motor
▪
Ice Hopper & Agitator Motor
Disassembly ID-0450
35