37
Telephone remote Operation
Arm /DISArm AND OPerATe
AuX OuTPuTS bY PHONe
Navigator control panels allow a
user to call in to the panel, using
a standard DTmF telephone, and
remotely arm or disarm all areas
and also turn on or off the Auxil-
iary outputs.
To maintain panel security, remote
operations can only be activated
after entering a valid user code.
To operate the panel by tele-
phone, you need a DTmF capa-
ble telephone, a valid user code
and you must know the telephone
number of the line to which the
panel is connected.
Notes
• If the panel does not receive com
-
mands for periods longer than 10
seconds it will assume that the call
is finished and it will hang up.
• If an alarm occurs which requires
the panel to dial out while attempt-
ing remote control, the panel will
treat the alarm as a priority, give
a constant tone as a warning and
then hang up.
AuDIble FeeDbACK
SequeNCe OF OPerATION.
1. Phone the panel telephone number and listen for the
required number of rings and then hang up.
2. Wait 10 seconds and then call the number again within
50 seconds.
3. The panel will answer the second call immediately,
sound a beep for 2 seconds then, after a pause, it
will sound a lower frequency tone. The panel is now
ready to receive telephone commands.
4. Press the
button on the telephone. This tells the
panel that telephone commands will follow. The panel
will respond with either 3 beeps if all OK (One long
beep means try again).
5. Now enter a valid User Code (that is normally used
for arming or disarming the panel) followed by the
button.
The panel will respond with 3 beeps if it recognises
the code or 1 long beep to signal the code was invalid
and to try again.
6. enter the required command. See the summary of
telephone commands below.
7. Press
to finish. This tells the panel to hang up.
Also hang up your telephone.
TelePHONe COmmANDS
Prepare to receive commands
Arm Areas
Disarm Areas
Turn ON or Pulse AUX1
Turn OFF AUX1
Turn ON or Pulse AUX2
Turn OFF AUX2
Turn ON or Pulse AUX3
Turn OFF AUX3
Turn ON or Pulse AUX4
Turn OFF AUX4
Finished – hang up
3 BeePS
• The User Code is valid
• Successful arm or disarm
• An AUX output has been
turned ON.
1 lONg BeeP
• Panel is already armed
• Invalid code. Try again.
• Remote AUX operation is not
enabled
1 ShOrT BeeP
• An AUX output has been
turned OFF.