32
Programming user Codes
The option number
and the current user code
is displayed.
Note 1. User codes must NOT
start with zero. (The panel will
allow codes beginning with zero
to be programmed but they will
not operate the panel. This is an
alternative method for disabling
user codes.)
Note 2. All codes must be unique
to each other. Codes are rejected
if already used. Some codes that
are similar to existing codes may
also be rejected.
Touch to delete a user code.
In User Program mode.
refer to the User Code options table on page
31 then enter the option number of the user
code you want to program.
Touch
+
+
3 digit option
number
Now enter your new user code (PIN). The
code can be 3 to 6 digits in length.
Touch
+
Then enter the PIN again to confirm.
Touch
+
Your new PIN
Your new PIN
The new user code will be displayed.
Arm ONlY CODeS
If a code has been programmed
by your installer to be an Arm
Only code, then that user code can arm but not
disarm the panel. This is handy for cleaners,
temporary staff etc.