3-18 Switching the Power On
Rev AA
Switching the Power On
To switch the printer on, turn the power switch on the CLARiTY
controller to the I (On) position (Figure 3-16).
The boot-up takes approximately 90 seconds. During this a "starting
CLARiTY …" message appears. Following this, the CLARiTY home page
(Figure 3-17 on page 3-19) is displayed.
An initialization process of 15 seconds begins, during which the printer
calibrates the ribbon drive. The status bar flashes the words STARTING
UP and the amber LED flashes on and off. When the process is complete,
the home page changes, as follows:
• The CLARiTY status panel changes from STARTING UP to OFFLINE.
• The Consumables area displays the percentage of ribbon remaining.
• In the Control Frame, the Start and Stop buttons are enabled.
• The blue Power LED on the printer is illuminated.
Figure 3-17 on page 3-19 displays the CLARiTY home page in the
OFFLINE state.
Figure 3-16: Printer Power Switch
Power Switch
ICE
P
egasus
Service Manual
