14
Pull through any slack cable. While holding the cable taut, turn the shifter through its range of movement to
check the cable moves smoothly and that the cable is properly seated inside the shifter. Run the cable under the
cable anchor washer and hold taut. Tighten the 5 mm hex cable anchor bolt to 5 Nm (44 in.lbs.). Be careful not
to crush or deform the cable.
TIP - Do not trim any cables until you are happy with the various settings of front
boom and gears. The loose end of the cable can be tightly coiled so that it is out of
the way.
2.12 Install and connect the rear derailleur
Find the bag with the rear derailleur parts in it. Fit the rear derailleur to the rear dropout using a 5mm hex key,
making sure the B-tension washer tab / b-adjust screw is clear of the rear derailleur dropout tab. Tighten the 5
mm hex hanger bolt to 70 – 85 in.lbs. (8 – 10 Nm).
Summary of Contents for B1
Page 4: ...4 1 1 Overview ...
