10
2.4b Assembling the seat – hard-shell seat
The hard-shell seat is supplied with 2 seat mounting
brackets, which have to be fastened to the seat. The
lower bracket is the wider one, and fastens
underneath through the pre-drilled holes. The upper
bracket is narrower, and should be mounted in the
lower position. The upper position should not be
used.
The flag mount bracket consists of 2 metal clips and a
short length of stainless steel tubing with one end
partially closed. The flag mount is positioned on the
back of the seat as shown in the photograph, with the
closed end facing down.
To install the breathable cover, remove the protection from the Double Faced Tape and stick the cover to the
seat.
2.5 Fit the seat
The seat is provided with 4 plastic SP-6 clamps. Two of these
clamps go around the bottom seat rail, and the other 2 go around
the top rail on the hard-shell seat or the 3
rd
rail (counting from the
bottom) on the mesh seat.
The 2 clips that go around the bottom rail are provided with quick-
release clamps. Place the clips on the bottom rail as shown in the
picture below, and then screw the quick-release into the clip. Do not
forget the small plastic spacer; the quick-release will not work
reliably without it.
The 2 clips that go on the upper rail are provided with M5 fasteners;
quick-releases are not necessary as the seat mount is held to the
frame with a quick-release. Clip the SP-6 clamps to the rail and
thread the bolts into place.
Summary of Contents for B1
Page 4: ...4 1 1 Overview ...
