11
Set the 5 position upper seat mount in
the lowest position (see photo). There
is a quick-release skewer that goes
through the front hole on the top of the
rear section. Place the seat onto the
bike and fasten in place with the 4
plastic clips supplied (quick-release clips
on the bottom, and bolted clips on the
top) and then tighten the 2 lower quick-
releases. Tighten the upper seat mount
quick-release, and then tighten the 2
upper plastic clip bolts.
2.6 Fit the chainset
You now need to install the left and right sides of the chainset. Your bike is supplied with the bottom bracket
already installed. It is every important to follow these instructions exactly. If the chainset is not installed
correctly, it will develop play and annoying movement soon after being put into service.
Grease the inner bearing races as shown in the diagram. Grease is good… don’t be afraid of using too much. Slide the
right crankarm and spindle assembly through the bottom bracket until the left side splines come through the left
bottom bracket cup, and the spindle stops. There will be a gap of about 3mm between the right crankarm and the
bottom bracket.
Summary of Contents for B1
Page 4: ...4 1 1 Overview ...
