ELEVATION SERIES CIM CUBERS
EVAPORATOR REPLACEMENT
55
When reinstalling screws into the base be sure to not exceed a torque of 30in‐lb to avoid striping them.
Pull bottom of frame out to clear left hand surround.
Surround
Grasp and remove Evaporator freeing the
Left Hand side first. The Left Hand
Surround will come out with the
Evaporator; the Right Hand surround will be
left in place. Once the Evaporator is out,
separate the surround from the Evaporator
by removing the five – 1/4” Screws on the
Left Hand side of the Evaporator. Remove
Curtain Switch on Right Hand side of
Evaporator and place on new Evaporator
and mount Left Hand Side surround on new
Evaporator.
Remove old silicone from base where shown
in picture. Run a 3/8” bead of silicone
included with Evaporator kit to replace
existing where surround and Evaporator
meet on the base.
Install Evaporator and reverse procedure for installation of components. Be sure to replace the Drier
on all open system repairs.
Summary of Contents for CIM2046
