Ice Appliance Gele, Instruction Manual

Page: 5 / 6

Maintenance:

Clean the machine frequently. When cleaning, unplug the unit and remove the ice cream. Use
a diluted solution of water and vinegar to clean the inside and the outside surface of the Ice
cream maker. Do not spray Ice cream maker with chemicals or diluted agents such as acids,
gasoline or oil. Rinse thoroughly before starting.

Remove the mixing blade assembly from the appliance before washing the assembly.

Always unplug the unit from the outlet when not in use.

Do not spill on or immerse cord plugs, main housing, motor assembly or other non-removable
electrical parts of this appliance in water or other liquid.

Do not let cord hang over edge of table or counter or touch hot surfaces.

Be certain unit is “off” before inserting or removing plug from wall outlet.

Keep hands and utensils out of container while operating to prevent the possibility of personal
injury or damage to the appliance machine. A scraper may be used, but must be used only
when the appliance is not running.

To operate the appliance you must have the cover lid in place.

If the compressor stops for any reason wait 3 minutes, and then re-start.
WARNING
.If the supply cord is damaged; it must be replaced by the manufacturer, its service agent or a
similarly qualified person in order to avoid a hazard.
This appliance is not intended for use by persons (including children) with reduced physical,
sensory or mental capabilities or lack of experience and knowledge unless they have been given
supervision or instruction concerning use of the appliance by a person responsible for their safety.
Children should be supervised to ensure that they do not play with the appliance.
Do not immerse in water
TROUBLESHOOTING
•
The paddle is not turning : if the machine has just started there is a delay for a few
minutes as a safety precaution. Make sure too that the transparent cover is locked into
place and the churn motor is plugged in properly. Alternatively, you may have added to
many hard ingredients like nuts or the mix may have become too frozen in which case stop
the Mix button, remove the motor and lid, and GENTLY remove the paddle. If it is
difficult to remove, switch the machine off and wait for the mix to soften first.
•
I broke my paddle! Spare parts are available from your original supplier or just contact
the address below
•
My mix is too hard : just take the bucket out of the machine and allow to defrost but
remember not to re-freeze once it has softened
•
My mix is too soft after 50 minutes The default timer is set at 50 minutes but you may
need to continue mixing and/or chilling depending on how much you are making and what
type of dessert. Remember, the warmer the room temperature and the ingredients the