iCanView222 User’s Guide
Identify the type of the network environment and set up IP address. Detailed process of
setting up IP address can be found in
[IP-Installer User’s Guide]
.
If network type is
xDSL or Cable modem you need supplementary information provided by your ISP.
4.
Connect to iCanView222 in Administrator Mode for initial parameter set-up.
All parameters are set to factory default state when iCanView222 is delivered. You are
asked to configure the system for your environment in administration mode. Detailed
information of using administration mode can be found in
[5.
Configuring iCanView222
in Administrative Mode]
. Among the parameters, the parameters in the following table
should be set-up with proper values. Detailed information for the parameters in
Administrator Mode is found in
[5.
Configuring iCanView222 in Administrative Mode]
[Note]: Set-up values are preserved even the power is turned off.
Page
Parameter
Setup value
Factory default value
Basic Setup
Video Size
Set the resolution of the video
transmitted from iCanView222.
Make sure that you press Check
button to find out the number of
maximum possible simultaneous
sers then set the number of
users smaller than or equal to the
mber.
u
nu
Max Upload Rate
Set this value smaller than the upload
speed of your network.
Frame Rate
The number of frames to be
transmitted per second.
Video Rate
Bandwidth assigned for video
transmitted from iCanView222.
User Admin
& Time
Setup
Administrator
name &
password
For safety, you are recommended to
change these values from factory
default. For new connection, you need
to input changed values for
corresponding fields. Do not disclose
these values to others and memorize
these values.
Default value
Username : root
Password : dw2001
User Admin
& Time
Setup
Current Time
Input correct time in this field.
Default value :
2001/1/1
5.
Connect the input and output signals to iCanView222.
Rev.1.0 (Mar. 2008)
15
