Instructions Manual
10
6. Advance setting
The advance setting interface permits to set the following
Options:
*Parameter:
Permits to change the time of Holding time and Drying time.
*Unit:
Permits to change the unit of measure temperature and pressure.
*Preheat:
This option allows you to maintain the required temperature in the sterilization chamber and the steam generator
to start a new cycle immediately for the next 60 minutes so to run a new cycles should expect preheating time from 3 to 5
minutes upon start.
If the option is disabled (OFF) once the sterilization cycle end immediately the Autoclave is no longer heated, so when you
start a new cycle should expect a preheating time between 3 to 5minutes upon start.
Note:
To maintain the temperature for longer time it is recommended that after each cycle hold the door closed.
Enter the setting
Power on the machine while holding the
button and hold for 5 seconds. This will
enter into the advanced setting mode.
6.1 Parameter
Tap
button to select Parameter. Tap
button to enter the menu.
Select the program that you need to change by Taping
button. Tap
button to
enter the setting.
Adjust the parameter by taping the
button.
Drying time:0-20 minutes
121
℃
holding time: 20-60 minutes
134
℃
holding Time: 4-20 minutes
After you finish adjusting the parameter Tap
button to save and return to the
above menu. Tap
button to cancel and exit.
6.2 Unit
Select the “Unit” to adjust the unit of temperature and pressure.
Tap
button to enter the menu.
Select the item by Taping
button.
Change the unit by Taping
button.
Pressure: kPa/bar/psi
Temperature:
℃/F
Tap
button to save and exit. Cancel and Exit by Taping
button.
6.3 Preheat
Select the “Preheat” to adjust the Preheat.
Tap
button to enter the menu.
If you don’t want to preheat after switch on, set the value to OFF by Taping
button.
Tap
button to save. Tap
button to cancel and exit.
Parameter
Unit
Preheat
SOLID(121
℃
)
SOLID(134
℃
)
WRAPPED(121
℃
)
WRAPPED(134
℃
)
Holding Time:20.0
Dry Time:02
Pressure: kPa
Temperature: C
Preheat: ON
Summary of Contents for STE-23-D
Page 1: ...STEAM STERILIZERS Instructions Manual For Model STE 23 D...
Page 2: ......
