96
Parameter
Function
Subject
Input email subject here.
Attachment
System can send out the email of the snapshot picture once
you check the box here.
Receiver
Input receiver email address here. Max three addresses.
It supports SSL, TLS email box.
Interval
The send interval ranges from 0 to 3600 seconds. 0 means
there is no interval.
Please note system will not send out the email immediately
when the alarm occurs. When the alarm or the abnormity
event activates the email, system sends out the email
according to the interval you specified here. This function is
very useful when there are too many emails activated by the
abnormity events, which may result in heavy load for the email
server.
Health mail
enable
Please check the box here to enable this function.
Update period
(interval)
This function allows the system to send out the test email to
check the connection is OK or not.
Please check the box to enable this function and then set the
corresponding interval.
System can send out the email regularly as you set here.
Email test
The system will automatically sent out a email once to test the
connection is OK or not .Before the email test, please save the
email setup information.
5.9.2.5 Alarm Centre
The alarm centre interface is shown as below. See Figure 5-29.
This interface is reserved for you to develop. System can upload alarm signal to the alarm centre
when local alarm occurs.
Before you use alarm centre, please set server IP, port and etc. When an alarm occurs, system
can send out data as the protocol defined, so the client-end can get the data.
Figure 5-29
