IC Bus Gasoline CE Series, Operation And Maintenance Manual

Page: 94 / 241

Seating and Safety Restraints
Passenger Two-Point Seat Belt (Lap Belts)
To loosen the belt, slide the latch up the webbing as far as
necessary to make the belt go around the passenger's lap.
Insert the latch plate into the buckle until secure. To loosen, pull
up on the lap belt. Tighten the belt until it is snug by pulling on
the loose end of the belt. Push the release button on the buckle
to release the seat belt. Position the lap portion of the belt so
that the webbing is below the passenger's waist,, not over the
stomach or abdomen area. The lap portion of the belt must be
low and snug over the bony structure of the passenger's hips.
Passenger Three-Point Seat Belts (If Equipped)
Buckling Up
1. The passenger should sit as flat against the seat back
as possible to achieve the best possible fit of the
lap-shoulder belt on the passenger's upper and lower
torso.
2. Pull out the shoulder belt webbing from the upper seat
back. Do not let the belt get twisted. (The shoulder belt
may lock if pulled across the body too quickly. If this
happens, let the belt retract slightly to unlock it. Then
pull the belt across you more slowly).
80