CamBoss
12 / 19
Trolley wheels
For different pipe diameters and surface materials, more sets of additional trolley wheels are
available. These wheels are either screwed onto the existing trolley wheels using the supplied
screws, or directly on the wheel axis. For plastic pipes, where rubber wheels may slip, try the
ceramic wheels.
13. System maintenance
The system maintenance is very important and leads to a significant prolongation of service
life and lower operating costs. Therefore it should not be neglected in any way.
The system components must be cleaned regularly. Do not wash system components with
pressurized water! After each inspection, remove any coarse dirt. After each day, wash the
components with water to remove coarse dirt such as sand, etc. and remove the wheels once
a week to remove the dirt underneath. Remove any tangled strings, hairs, etc. from the axles.
Such dirt and debris are very dangerous to the wheel axle seal. You can also perform cleaning
more frequently, at your discretion.
Maintenance of cable winch
It is essential to keep the entire winch mechanism clean. This particularly means the
trapezoidal screw that is used to align the cable onto the drum. It is recommended to remove
coarse dirt such as sand, papers, etc. from the cable. Check the entire winch mechanism
regularly to remove any debris. Lubricate the chain and the entire cable alignment mechanism
regularly with non-sagging grease. Only perform these operations with the equipment
switched off and the supply voltage disconnected! Secure the drum so that the cable cannot
be pulled during maintenance and cause the injury by rotating drum.
When installing threaded components, use petroleum jelly and related sealing elements to
ensure maximum sealing effectivity. Do not use excessive force when tightening the threads,
this will prevent them from being stripped or damaging components.
14. Troubleshooting
The camera system is protected by a number of fuses and protections. If the fuse is blown,
turn off the device and disconnect it from the power supply. Secure against turning back on.
You can try to replace a blown fuse. Never use different type of fuse, especially a different
current value than the original fuse has.
Try to correct the cause of the fault using the information provided herein below. If the cause
remains unclear or the suggestions for correction do not lead to successful correction of
problem, please contact IBOS a.s. customer service.
