IBM WebSphere DataPower XC10, Installation Manual

Page: 27 / 52

Chapter 2. Preparing for installation
This section provides information about the installation requirements and
overview.
Skills required
To set up and administer the appliance, you need network administration skills.
Information required
You need to collect the following data to define your WebSphere DataPower XC10
base configuration.
v
The IP address and subnet mask for the Ethernet interface for appliance
management access (MGMT).
v
The IP address of the default gateways (routers) that supports the subnets for
the Ethernet interfaces.
v The IP address of the Domain Name System (DNS) server. The DNS server
should be configured for both forward and reverse look ups.
v
Communication parameters for serial interface: 9600.8.n.1 (9600 baud, 8 data bits,
no parity, 1 stop bit).
v
Mail server information (to set up e-mail notifications).
Note: Configuring the mail server is optional but highly recommended.
v
Storage space, in a location other than the appliance, to create a backup. A
backup could reach 100 GB in size, depending on content.
v
(Optional) The IP addresses and subnet mask for Ethernet interfaces for
appliance service access (ETH0, ETH1, and ETH2).
Note: You can use the MGMT Ethernet interface on a dedicated subnet for all
network and system-wide management functions. This dedicated subnet
handles network traffic for the user interface functions.
Rack requirements
To install the WebSphere DataPower XC10 appliance, you need a standard 19 inch
(48.26 cm) rack with a minimum of 25 inches (63.5cm) of depth that meets the
following criteria:
v
Provides rear mounting columns
v
Supports both front and rear mounting
v Provides rear mounting columns
v
Supports both front and rear mounting
You also need to ensure that the following required space in and around the rack
is available:
v
At least 30 inches (76.20 cm) of free space behind the rack
v
At least 2 inches (5.1 cm) above and below the appliance
v
Sufficient free space in the front for Ethernet and any serial console cables
© Copyright IBM Corp. 2010
7