IBM TURBOWAYS 622 PCI MMF ATM, Installation And Using Manual

Page: 25 / 44

v
VPI:VCI
– Type
0:x
, where
x
equals a number from 0 to 1023 and press Enter.
Note: The virtual path identifier (VPI) must be 0. The valid range for the
virtual channel identifier (VCI) is determined by the number of virtual
channels (VCs) supported by the switch and the number of VCs
reserved for PVC connection.
v
Network Interface
Type
at0
and press Enter.
v
Destination IP Address
If you set the Automatically Discover Destination IP Address field to no, type the
dotted decimal IP address (for example,
162.62.41.96
) of the destination end
station (ATM-attached host or gateway) and press Enter.
v
Automatically Discover Destination IP Address
Select yes or no and press Enter.
v
LLC Encapsulation
LLC Encapsulation determines whether Logical Link Control / Subnetwork
Access Protocol (LLC/SNAP) or null encapsulation is used on the PVC. Select
yes or no and press Enter.
4. When the Command status in the Command Status screen changes from
running
to
OK
, press F3 to return to the PVCs for IP over an ATM Network menu.
5. To verify that the configuration is correct, select List All PVCs for IP over an ATM
Network.
6. When the Command status in the Command Status screen changes from
running
to
OK
, press F3 to return to the PVCs for IP over an ATM Network menu.
7. If you need to make changes, continue with the next step; otherwise, press F10 to
exit SMITTY.
8. From the PVCs for IP over an ATM Network menu, select Change / Show
Characteristics of a PVC for IP over an ATM Network.
9. From the list of Available Interfaces, select at0.
10. If necessary, change values in the Change / Show Characteristics of a PVC for IP
over an ATM Network screen and press Enter.
11. When the Command status in the Command Status screen changes from
running
to
OK
, press F10 to exit SMITTY.
ATM622 Software Removal Procedure
To remove the ATM622 software, do the following:
1. Log in to the AIX operating system as root.
2. At the AIX command prompt, type
smitty inet
and press Enter.
3. From the Network Interface Selection Menu, select Remove a Network Interface.
4. From the Available Network Interfaces list, select at0.
5. When the Command status in the Command Status screen changes from
running
to
OK
, press F10 to exit SMITTY.
Chapter 6. Configuring and Using ATM622 Software
17