IBM TURBOWAYS 622 PCI MMF ATM, Installation And Using Manual

Page: 24 / 44

- For server connections svc_s, no address is required. Leave this field
blank.
– Alternate Devices
- Data not required; leave field blank.
– Idle Timer
- Data not required; leave field blank.
– ACTIVATE the interface after creating it?
- To activate the interface, select the default, yes.
7. When the command status in the Command Status screen changes from
running
to
OK
, press F10 to exit SMITTY.
To set the host name, a name server, or a gateway, continue with the next section.
To use permanent virtual channels (PVCs), go to “Configuring the Adapter to Use
PVCs”.
Setting the Host Name, Name Server, or Gateway
To set the host name, name server, or gateway, do the following:
1. At the AIX command prompt, type
smitty tcpip
and press Enter.
2. From the TCP/IP menu, select Minimum Configuration and Startup.
3. From the list of Available Network Interfaces, select at0.
4. The Minimum Configuration and Startup screen displays.
5. Type the information for the host name, name server, or gateway in the Minimum
Configuration and Startup screen and press Enter.
Note: See your system administrator for the required addresses.
6. When the Command status in the Command Status screen changes from
running
to
OK
, press F10 to exit SMITTY.
Configuring the Adapter to Use PVCs
Note: You can configure the TURBOWAYS 622 PCI MMF ATM Adapter to use PVCs
with or without configuring SVCs.
To configure the TURBOWAYS 622 PCI MMF ATM Adapter to use PVCs, do the
following:
1. At the command prompt, type
smitty atmpvc
and press Enter.
2. To add PVCs for internet protocol (IP) on an ATM network, select Add a PVC for
IP over an ATM Network.
3. If you want to change a value in the Add a PVC for IP over an ATM Network
screen, find the appropriate instruction below and implement the relevant steps:
v
PVC Description
– The PVC Description is an optional field.
16
Installation and Using Guide