IBM TURBOWAYS 622 PCI MMF ATM, Installation And Using Manual

Page: 19 / 44

__ 1. Make sure that the lppsource directory is exported to the nodes by typing the
following at the system prompt:
showmount -e
If the directory is exported to the nodes, the result should look similar to the
following:
/spdata/sys1/install/AIX433/lppsource (everyone)
__ 2. If the directory is not exported, you may temporarily export the directory by
typing the following:
exportfs -i /spdata/sys1/install/<lppsource_name>/lppsource
__ 3. Perform an NFS mount of the lppsource directory by typing the following:
dsh mount <controlwks>:
/spdata/sys1/install/<lppsource_name>/lppsource /mnt
<controlwks>
is the name of the Control Workstation recognized by the nodes.
<lppsource_name>
is the name you recorded earlier in “Checking System
Prerequisites” on page 7.
__ 4. Perform a preview of the files to be installed on the nodes by typing the following
at the system prompt:
dsh "installp -p -acqXd /mnt device driver 2>&1" | more
device driver is the fileset that must be installed for the adapter. The list includes:
v
devices.pci.14105e01
__ 5. Install the device driver by typing the following at the system prompt:
dsh "installp -acqXd /mnt device driver 2>&1" | more
device driver is defined in the previous step.
After the device driver is installed on the node, contact your service provider to
have the adapter installed.
Chapter 4. Installing the Device Driver on the RS/6000 SP System
11