IBM Turboways 155, Installation And User Manual

Page: 20 / 36

3. If you desire to change a value in the Add a PVC for IP over an ATM Network
screen, find the appropriate instruction below and implement the relevant steps:
Ÿ
PVC Description
– The PVC Description is an optional field.
Ÿ
VPI:VCI
– Type the following, where x equals a number from 0 to 1023.
ð:x
and press Enter.
Note: The virtual path identifier (VPI) must be 0. The valid range for the
virtual channel identifier (VCI) is determined by the number of virtual
channels (VCs) supported by the switch and the number of VCs reserved
for PVC connection.
Ÿ
Network Interface
– Type
atð
and press Enter.
Ÿ
Destination IP Address
– If you set the Automatically Discover Destination IP Address field to no,
type the dotted decimal IP address (for example,
162.62.41.96
) of the
destination end station (ATM-attached host or gateway) and press Enter.
Ÿ
Automatically Discover Destination IP Address
– Select yes or no and press Enter.
Ÿ
LLC Encapsulation
– LLC Encapsulation determines whether Logical Link Control/Subnetwork
Access Protocol (LLC/SNAP) or null encapsulation is used on the PVC.
Select yes or no and press Enter.
4. When the Command status in the Command Status screen changes from
running
to
OK
, press F3.
5. SMITTY returns you to the PVCs for IP over an ATM Network screen.
6. To verify that the configuration is correct, select List All PVCs for IP Over an
ATM Network.
7. When the Command status in the Command Status screen changes from
running
to
OK
, press F3.
8. SMITTY returns you to the PVCs for IP over an ATM Network menu.
9. If you need to make changes, continue with the next step; otherwise, press F10
to exit SMITTY.
3-4
Installation and User's Guide