IBM Turboways 155, Installation And User Manual

Page: 17 / 36

Chapter 3. Configuring and Using ATM155 Software
This chapter explains how to configure and how to use ATM155 software for AIX.
Included are guidelines for implementing an ATM Address Resolution Protocol (ARP)
server. Before you perform these instructions, it is advisable to read Chapter 4,
“Managing the Network” on page 4-1.
Configuring the Adapter
To configure the TURBOWAYS 155 PCI UTP ATM Adapter:
1. Turn your system unit power on.
2. Log on to the AIX operating system as root.
3. At the AIX command prompt, type the following and press Enter.
smitty inet
Note: The
ifconfig
command is not compatible with the ATM Network
Interface Driver (NID). Use only the SMITTY application when configuring the
ATM NID.
4. From the Network Interface Selection menu, select Add a Network Interface.
5. From the Add a Network Interface menu, select Add an ATM Network
Interface.
6. Set the values in the Add an ATM Network Interface screen via instructions
below:
Ÿ
INTERNET ADDRESS
– Type the dotted decimal Internet Protocol (IP) address assigned to your
workstation (for example,
1ð.125.26.89
) and press Enter.
Ÿ
Network MASK
– Type the dotted decimal IP network mask for your workstation (for
example,
255.255.255.ð
) and press Enter.
Note: To get the addresses, see your system administrator.
Ÿ
Network Interface
– Type
atð
and press Enter.
Chapter 3. Configuring and Using ATM155 Software
3-1